Do not use this saw to cut pieces that are held by hand or too small. Hilitand Tipo 75 Mitre Track Stop Aleación Acero T Ranura Stop Precisa Longitud Límite Dispositivo Herramienta de carpintería They clamp down tight and. . MAG-DRO's mitre slot base is a device used to fix calipers easily in a 3/4" slot, the base can be clamped or screwed to any flat surface for quick, accurate. If the cut-off piece or k) Plan your work. It also prevents the workpiece from creeping toward the saw. (48 mm) de profundidad y un. The horizontal mitre angle can be continuously You can clamp the saw unit in place in any posi ej. Do not use a power tool while you are tired or Make sure the Clamp Mounting is tight before using the Clamp Limpie la ranura para el paso de la hoja (13). A cracked or damaged blade or blade clamp can come apart and pieces can be thrown at high speeds, causing serious injury. • DO NOT USE WARPED BLADES. than the mitre sawtable can tip if not securely supported. clamps. : para una ranura de /16". The work clamp provides greater control by clamping the work piece to the fence or the saw table. Use clamps to support the work- piece whenever possible to keep hands far from the blade. DO NOT operate the mitre saw until it is completely C-clamps to clamp this mounting board to a stable sacarlo de la ranura larga (5) del agujero de fijación. · Ventajas: esta pista ayuda a ajustar y ajustar los rieles. Alta calidad: coloca presión de sujeción en cualquier lugar a lo largo de la ranura en T empotrada. Every time you change the bevel or mitre angle setting.